Network Implementation Summary ā Network Implementation Summary Static IP Configuration: First, I configured two networks with static IPs. These two networks were then connected to a load balancer. One network was set as the primary, and the other as the secondary/failover network. Load Balancer Setup: After configuring the load balancer, I ensured both networks were routed correctly for redundancy and traffic balancing. Switch Connection: Used an RJ45 cable to connect the load balancer to a 24-port PoE (Power over Ethernet) switch. Access Point Deployment: Connected 10 TP-Link access points to the PoE switch (using the PoE ports for both power and data). Configured all access points using the TP-Link controller/adapter software. IP Scheme: The network used a "0 series" IP scheme (e.g., 192.168.0.x). All TP-Link access points were assigned IPs from the 0 series range. Connectivity Testing: Verified internet connectivity on each access point individually. All access points were successfully connected and fully operational.